CAD CAM EDM DRO - Yahoo Group Archive

Re: Newbie question about DFX vs. STL

Posted by imserv1
on 2002-07-08 15:42:34 UTC
--- In CAD_CAM_EDM_DRO@y..., Bill Vance <ccq@x> wrote:
> Hi folks;
>
> Are there reasonable progs for translating DXF/STL files back and
forth? I
> wouldn't mind extra views if needed.
>

There are no views associated with an STL file. It simply is 3D.
Same for a DXF translation of one.

This is about as cheap as you can get and it is loaded with all kinds
of 3D goodies too.

Accutrans

http://www.micromouse.ca

An Accutrans license is included with each StlWork sale.

Best Regards,

Fred Smith
IMService We are THE source for low cost Cad-Cam

Discussion Thread

exeric1 2002-07-08 07:15:32 UTC Newbie question about DFX vs. STL imserv1 2002-07-08 10:02:40 UTC Re: Newbie question about DFX vs. STL Bill Vance 2002-07-08 11:24:48 UTC Re: [CAD_CAM_EDM_DRO] Newbie question about DFX vs. STL imserv1 2002-07-08 15:42:34 UTC Re: Newbie question about DFX vs. STL