stepper drive info
Posted by
R.Dean, Nr Atlanta, GA
on 1999-05-29 19:24:17 UTC
I sure would like to see this Drive diagram. Finding cnc info
sources is very difficult. I can build one from a schematic.
Dan, is this available via web or e/m? regards, Rich Dean
(snip)
.
.~ ~ ~~ ~~____~,~~ ~~~__
. \------ |OO|_[]_[]__\/O
. .|_CMRy_|-|__|________|_|.
.____oo__oo__--"O=O=O"=[]oo\\____________________________________
.--Colorado Midland Railway---Rich---cmsteam@...---KT4IZ.
sources is very difficult. I can build one from a schematic.
Dan, is this available via web or e/m? regards, Rich Dean
(snip)
>My favorite DIY stepper drive is the Ericsson design that Dan Mauch has--
>now. It uses 2 ICs and 8 mosfets to put out over 5 amps. Apparently, with
>good design, and good shielding, good airflow, it should be able to put out
>10 amps- I ran 9 amps for a little while, before roasting some mosfets.
>Ask Dan about the 5amp boards/kits.
>Dan Falck
>Nashville,TN.
.
.~ ~ ~~ ~~____~,~~ ~~~__
. \------ |OO|_[]_[]__\/O
. .|_CMRy_|-|__|________|_|.
.____oo__oo__--"O=O=O"=[]oo\\____________________________________
.--Colorado Midland Railway---Rich---cmsteam@...---KT4IZ.
Discussion Thread
R.Dean, Nr Atlanta, GA
1999-05-29 19:24:17 UTC
stepper drive info
Dan Falck
1999-05-29 21:07:26 UTC
Re: stepper drive info
Dan Mauch
1999-05-30 05:56:43 UTC
Re: stepper drive info