Re: stepper drive info

I sell a silkscreen Printed circuit board that makes it easy if you want to
do it from scratch. But I also have a complete kit. See my webpage at
http://www.seanet.com/~dmauch

Quite a few people have built them. Talk to Tim Goldstein on this group. He
can tell you what he thinks about the 5 amp kit.
Dan
-----Original Message-----
From: R.Dean, Nr Atlanta, GA <cmsteam@...>
To: CAD_CAM_EDM_DRO List <CAD_CAM_EDM_DRO@onelist.com>
Date: Saturday, May 29, 1999 7:24 PM
Subject: [CAD_CAM_EDM_DRO] stepper drive info

>From: "R.Dean, Nr Atlanta, GA" <cmsteam@...>
>
>I sure would like to see this Drive diagram. Finding cnc info
>sources is very difficult. I can build one from a schematic.
>Dan, is this available via web or e/m? regards, Rich Dean
>
>(snip)
>>My favorite DIY stepper drive is the Ericsson design that Dan Mauch has
>>now. It uses 2 ICs and 8 mosfets to put out over 5 amps. Apparently,

with

>>good design, and good shielding, good airflow, it should be able to put

out

>>10 amps- I ran 9 amps for a little while, before roasting some mosfets.
>>Ask Dan about the 5amp boards/kits.
>
>>Dan Falck
>>Nashville,TN.
>
>--