Re: grizzli mini-mill: hard slides
Posted by
Ray Henry
on 2002-07-19 13:17:13 UTC
Bruno
These don't really come set up at all. On mine, I removed all the screws
and snugged the gibs with just a bit of Vactra oil and slid them end to
end. I found spots where they tended to drag worse than other spots and
honed those a little. After a while the slideways worked pretty well.
Ray
These don't really come set up at all. On mine, I removed all the screws
and snugged the gibs with just a bit of Vactra oil and slid them end to
end. I found spots where they tended to drag worse than other spots and
honed those a little. After a while the slideways worked pretty well.
Ray
On Friday 19 July 2002 11:14 am, you wrote:
> Message: 25
> Date: Fri, 19 Jul 2002 06:14:04 -0000
> From: "bschwand" <bschwand@...>
> Subject: grizzli mini-mill: hard slides
>
> Hi everybody,
>
> I just got my Grizzly mini-mill, and the slides are incredibly hard to
> move. I need to apply almost 10 pounds on the handle (if it is in the
> left/right position) to get it to move.
>
> I checked, and they are not locked.
>
> Is this normal ? Will it loosen up with use, or should I adjust the
> slides ?
>
> bruno
Discussion Thread
bschwand
2002-07-19 09:14:11 UTC
grizzli mini-mill: hard slides
Brian Pitt
2002-07-19 10:18:23 UTC
Re: [CAD_CAM_EDM_DRO] grizzli mini-mill: hard slides
Ray Henry
2002-07-19 13:17:13 UTC
Re: grizzli mini-mill: hard slides
bschwand
2002-07-22 10:58:10 UTC
Re: grizzli mini-mill: hard slides