Re: [CAD_CAM_EDM_DRO] cleaning a ball screw
Posted by
JanRwl@A...
on 2002-08-11 12:49:17 UTC
In a message dated 10-Aug-02 12:36:41 Central Daylight Time,
davemucha@... writes:
Though a TERRIBLE fuss, suggest you at least CONSIDER removing the ball-nuts
and balls, putting them in an appropriate container until ready to
re-assemble.
[Non-text portions of this message have been removed]
davemucha@... writes:
> I picked out the one that the ball moved freely on with the hopes of3M Brite-Rite (aka "Scotch-Brite") and WD-40. CAREFUL workmanship!
> using it. any ideas on the best way to remove light, medium and
> heavy rust ?
>
>
Though a TERRIBLE fuss, suggest you at least CONSIDER removing the ball-nuts
and balls, putting them in an appropriate container until ready to
re-assemble.
[Non-text portions of this message have been removed]
Discussion Thread
turbulatordude
2002-08-10 10:35:32 UTC
cleaning a ball screw
Jon Elson
2002-08-10 13:30:49 UTC
Re: [CAD_CAM_EDM_DRO] cleaning a ball screw
Bill Vance
2002-08-10 14:51:27 UTC
Re: [CAD_CAM_EDM_DRO] cleaning a ball screw
John
2002-08-10 15:20:23 UTC
Re: [CAD_CAM_EDM_DRO] cleaning a ball screw
cadcambee
2002-08-11 11:51:29 UTC
Re: cleaning a ball screw
JanRwl@A...
2002-08-11 12:49:17 UTC
Re: [CAD_CAM_EDM_DRO] cleaning a ball screw