parallel port signal to relay
Posted by
turbulatordude
on 2002-08-31 19:05:46 UTC
Hi all,
I am looking for a simple circuit to turn on my motor (spindle) and
a solenoid for compressed air for a mister.
I was looking to run it from the parallel port directly, so isolation
may be beneficial.
I had been looking at just using a darlington (photo darlington?) to
power a 1 amp board mounted relay or possible a TIP120 or similar,
then a high amp relay. I hate to power three devieces as it can lead
to more headaches.
My spindle is a 220 VAC 1/3 hp single phase so a standard relay will
work, but I am looking for experience from those who know what works
and what doesn't.
I'm using a direct cable to terminal strip as my breakout box. so I
will put together a board for this circuit.
In my searching it seems the posts talk about which breakout board to
use (have not hard of a bad one yet) but not the circuits themselves.
Dave
I am looking for a simple circuit to turn on my motor (spindle) and
a solenoid for compressed air for a mister.
I was looking to run it from the parallel port directly, so isolation
may be beneficial.
I had been looking at just using a darlington (photo darlington?) to
power a 1 amp board mounted relay or possible a TIP120 or similar,
then a high amp relay. I hate to power three devieces as it can lead
to more headaches.
My spindle is a 220 VAC 1/3 hp single phase so a standard relay will
work, but I am looking for experience from those who know what works
and what doesn't.
I'm using a direct cable to terminal strip as my breakout box. so I
will put together a board for this circuit.
In my searching it seems the posts talk about which breakout board to
use (have not hard of a bad one yet) but not the circuits themselves.
Dave
Discussion Thread
turbulatordude
2002-08-31 19:05:46 UTC
parallel port signal to relay
caudlet
2002-09-01 12:42:52 UTC
Re: parallel port signal to relay
dakota8833
2002-09-02 06:17:35 UTC
Re: parallel port signal to relay / source ?
turbulatordude
2002-09-02 07:13:52 UTC
Re: parallel port signal to relay / source ?
caudlet
2002-09-03 15:52:56 UTC
Re: parallel port signal to relay / source ?
caudlet
2002-09-03 15:52:59 UTC
Re: parallel port signal to relay / source ?
JanRwl@A...
2002-09-07 21:08:49 UTC
Re: [CAD_CAM_EDM_DRO] parallel port signal to relay