Re: [CAD_CAM_EDM_DRO] Loosing steps with Gecko 340 drive--Mariss?
Posted by
Steve Blackmore
on 2002-09-03 14:49:35 UTC
On Tue, 03 Sep 2002 16:21:15 -0000, you wrote:
Steve Blackmore
--
Pilot Consultancy Limited ***** Computer Consultants
Telephone 01744 752256 Mobile 07831 768478
Email: steve@... WWW: http://www.pilotltd.net
>I'm having an interesting problem. I've been playing around withDerek - they weren't by chance, IJ type moves? Where they?
>Arts Mach1 program. I noticed I was loosing steps when I ran
>some programs but not others. Art suggested that I lower the
>acceleration and sure enough no more lost steps. My question
>is If Mach1 was delivering steps at a faster rate than the servos
>could handle why didn't the Geckos fault out?
Steve Blackmore
--
Pilot Consultancy Limited ***** Computer Consultants
Telephone 01744 752256 Mobile 07831 768478
Email: steve@... WWW: http://www.pilotltd.net
Discussion Thread
tig415
2002-08-28 12:41:02 UTC
Loosing steps with Gecko 340 drive
Tim Goldstein
2002-08-29 11:25:58 UTC
Re: [CAD_CAM_EDM_DRO] Loosing steps with Gecko 340 drive
tig415
2002-09-03 09:21:20 UTC
Loosing steps with Gecko 340 drive--Mariss?
mariss92705
2002-09-03 10:24:42 UTC
Re: Loosing steps with Gecko 340 drive--Mariss?
JJ
2002-09-03 14:33:58 UTC
RE: [CAD_CAM_EDM_DRO] Re: Loosing steps with Gecko 340 drive--Mariss?
Steve Blackmore
2002-09-03 14:49:35 UTC
Re: [CAD_CAM_EDM_DRO] Loosing steps with Gecko 340 drive--Mariss?
art
2002-09-03 16:09:19 UTC
Re: [CAD_CAM_EDM_DRO] Re: Loosing steps with Gecko 340 drive--Mariss?
tig415
2002-09-04 04:25:00 UTC
Re: Loosing steps with Gecko 340 drive--Mariss?
tig415
2002-09-04 04:26:09 UTC
Re: Loosing steps with Gecko 340 drive--Mariss?