Feed rate mode - which is best to use
Posted by
mszollar
on 2002-09-11 14:05:50 UTC
I was wondering, what feed mode is best to use (generally), units
per minute or units per rev? THe reason I ask revolves around the
entire discussion on feed/speed. If you know the amount of cut each
rev should make wouldn't it be best to (nearly) always use units per
rev (assuming that you can measure your speed with some accuracy)?
When would you use one over the other when programming your CNC?
per minute or units per rev? THe reason I ask revolves around the
entire discussion on feed/speed. If you know the amount of cut each
rev should make wouldn't it be best to (nearly) always use units per
rev (assuming that you can measure your speed with some accuracy)?
When would you use one over the other when programming your CNC?