Re: Indent thing
Posted by
ahlee1010
on 2002-09-17 16:18:43 UTC
--- In CAD_CAM_EDM_DRO@y..., "Ian W. Wright" <Ian@i...> wrote:
step pulses (rotation of shaft induces current/voltage) to drive
bigger steppers. Any successess out there?
Lee
> Or a small stepper motor out of a disk drive with one or more of theThere were some mention of using a small stepper motor as a source of
> windings shorted?.... 200 'indents' per rev.
step pulses (rotation of shaft induces current/voltage) to drive
bigger steppers. Any successess out there?
Lee
Discussion Thread
William Scalione
2002-09-17 08:24:33 UTC
Indent thing
J
2002-09-17 09:18:14 UTC
Re: [CAD_CAM_EDM_DRO] Indent thing
jmkasunich
2002-09-17 10:13:43 UTC
Re: Indent thing
Brian
2002-09-17 14:27:55 UTC
Re: [CAD_CAM_EDM_DRO] Indent thing
William Scalione
2002-09-17 14:46:25 UTC
Re: [CAD_CAM_EDM_DRO] Indent thing
Ian W. Wright
2002-09-17 16:11:56 UTC
Re: [CAD_CAM_EDM_DRO] Indent thing
ahlee1010
2002-09-17 16:18:43 UTC
Re: Indent thing
robert weiss
2002-09-18 02:36:12 UTC
Ball plunger [was:RE: [CAD_CAM_EDM_DRO] Indent thing