Re: Two related questions, Sherlines and Steppers
Posted by
ahlee1010
on 2002-09-17 16:25:21 UTC
--- In CAD_CAM_EDM_DRO@y..., Alan Rothenbush <beer@s...> wrote:
There was a mention of using a voltmeter to determine the "polarity"
of the phase wires when the shaft are forced rotated? Would this have
been simpler rather than actually driving the motor with the 297/298?
Lee
> Turns out the point is moot. I DID rewire the motor, which is tosay, I
> brought all 8 leads out. From there, it was simply trial and errorto
> determine windings and phase, using a 297/298 driver.How was this trial and error done?
There was a mention of using a voltmeter to determine the "polarity"
of the phase wires when the shaft are forced rotated? Would this have
been simpler rather than actually driving the motor with the 297/298?
Lee
Discussion Thread
Alan Rothenbush
2002-09-15 12:21:14 UTC
Two related questions, Sherlines and Steppers
mariss92705
2002-09-15 13:24:31 UTC
Re: Two related questions, Sherlines and Steppers
Alan Rothenbush
2002-09-15 14:32:11 UTC
Re: Re: Two related questions, Sherlines and Steppers
mariss92705
2002-09-15 15:58:40 UTC
Re: Two related questions, Sherlines and Steppers
Alan Rothenbush
2002-09-15 16:51:49 UTC
Re: Two related questions, Sherlines and Steppers
ahlee1010
2002-09-17 16:25:21 UTC
Re: Two related questions, Sherlines and Steppers