Re: gecko for notebook

Hi,

I currently am using CNCpro and have just started experimenting with
Turbocnc, both are DOS programs. I would like to try Master5 or EMC but my
notebook is only an old P100 and wouldn't perform well with those programs
while it works fine with the DOS programs.

Al

At 05:06 PM 18/09/2002 +0000, you wrote:

>hi,
>
>very nice website!
>
>one question: i see in your wiring diagrams, that you had estop and all
>other limit, home inputs on same parallel port. what software do You use?
>
>other great guys on the list: is it possible with EMC to have estop on the
>one and only parallel port?
>
>thanks,
>
>vajk
>
>aschoepp wrote:
>
> > I'm using G201A's on a micro mill controlled with an old Toshiba
> > notebook. The following website has the wiring diagram I used and
> > the pinouts for PS2, keyboard and gameport that provide the +5v.
> >
> > http://members.rogers.com/schoepp4887/noframes/cnctaig.html
> >
> > Regards,
> > Al
> > http://www.schoepp.ca
> >
> > --- In CAD_CAM_EDM_DRO@y..., "alex0young" <alex0young@y...> wrote:
> > > Hi,
> > >
> > > How do I control a gecko driver from a notebook with very limited
> > > ports? From where can I get the +5V for the gecko?
> > >
> > > Thanks
> > >
> > > Young

[Non-text portions of this message have been removed]