CAD CAM EDM DRO - Yahoo Group Archive

Re: RS-232 motion control card

Posted by IMService
on 2002-10-04 15:23:20 UTC
> Date: Fri, 04 Oct 2002 19:54:35 -0000
> From: "byrogyro69" <byronhatfield@...>
>Subject: RS-232 motion control card
>
>I am very, very new to this stuff so bear with me. I am looking for
>a low cost motion controller card to run my Gecko drives. I am
>using BobCAD as my CAD and NC software and as far as I can determine
>it doesn't support the Parallel connection that the many of the
>boards for us penny pinchers use. Can anyone give me some info on
>this or knock me upside the head and ask me why I couldn't figure it
>out for myself?

Here is a link that has a list of and links to most of the software solutions that are available:

http://www.imsrv.com/controllers.html

Best Regards, Fred Smith- IMService

Listserve Special discounts and offers are at:
http://www.imsrv.com/grp.html

We are THE source for low cost Cad Cam

Discussion Thread

byrogyro69 2002-10-04 12:54:48 UTC RS-232 motion control card Tim Goldstein 2002-10-04 13:01:39 UTC Re: [CAD_CAM_EDM_DRO] RS-232 motion control card IMService 2002-10-04 15:23:20 UTC Re: RS-232 motion control card Bill Vance 2002-10-05 01:47:32 UTC Re: [CAD_CAM_EDM_DRO] RS-232 motion control card