Re: Newbie question. can I make my mill/drill full CNC?

on 2002-10-16 11:13:17 UTC

This nlooks like a great group! Is there a site or source that I can
make a full CNC out of my mill/drill? Do I need to change the srews
etc? It is a JMD18 mill/drill from Jet/toolsd that I purchased a few
months ago.
Thanks
Wally

Discussion Thread

fabman_engineer 2002-10-16 11:13:17 UTC Re: Newbie question. can I make my mill/drill full CNC? Cardinal.Eng 2002-10-16 18:14:04 UTC RE: Newbie question. can I make my mill/drill full CNC?