Re: estimating machining time

The EMC backplotter is real time. I did make a special ini with about
1/10 the steps and much faster speed so that I could get around those 3
hour contouring jobs in a few minutes.

Ray

>    From: "awallin25" <anders.wallin@...>
> Subject: estimating machining time
>
>
>
> Is there an easy way to estimate how long a g-code program will run??
> (automatically calculate toolpath length and divide by feedrate)
> I tried running EMC with only the backplotter active, no movement of
> the table, but this is a kind of slow way...