Re: Re: Another EMC Q: won't get out of Estop!
Posted by
Ray Henry
on 2002-10-16 16:11:50 UTC
What you are striving for are yellow axis position letters when tkemc
comes up. If they are red, it usually means that the limits are set to
the wrong polarity. If the letters will not turn green when you home but
the axis just keeps on moving then you need to change the polarity of the
home switch pin also.
Ray
comes up. If they are red, it usually means that the limits are set to
the wrong polarity. If the letters will not turn green when you home but
the axis just keeps on moving then you need to change the polarity of the
home switch pin also.
Ray
> From: "semenoff" <semenoff@...>
> Subject: Re: Another EMC Q: won't get out of Estop!
>
>
> Tim, thanks. I am using minimill for io and task.
> Robert
>
> --- In CAD_CAM_EDM_DRO@y..., "Tim Goldstein" <timg@k...> wrote:
> > Are you running bridgeportio or minimillio (Think that is the
>
> names)?
>
> > Bridgeportio requires 2 parallel cards to get out of e-stop.
> >
> > Tim
> > [Denver, CO]
> >
> >
> > > -----Original Message-----
> > > I recently upgraded from EMC 2.0 to 2.16 after
> > > having the older version more or less working.
> > > But now it refuses to come out of estop. I've
Discussion Thread
semenoff
2002-10-15 20:26:33 UTC
Another EMC Q: won't get out of Estop!
Tim Goldstein
2002-10-15 21:24:26 UTC
RE: [CAD_CAM_EDM_DRO] Another EMC Q: won't get out of Estop!
dakota8833
2002-10-16 07:03:18 UTC
Re: Another EMC Q: won't get out of Estop!
semenoff
2002-10-16 12:42:50 UTC
Re: Another EMC Q: won't get out of Estop!
semenoff
2002-10-16 14:18:54 UTC
Re: Another EMC Q: won't get out of Estop!
Ray Henry
2002-10-16 16:11:50 UTC
Re: Re: Another EMC Q: won't get out of Estop!