Re: Is Single Phase Adequate? Spindle Speed Adj
Posted by
vrsculptor
on 2002-10-25 14:56:26 UTC
--- In CAD_CAM_EDM_DRO@y..., "Doug Harrison" <prototype@c...> wrote:
jump in if this is incorrect. Art will probably have it available in
Mach1 eventually. Cncpro seems to be in its final form.
Mach1 has spindle control via step and direction since last week. For
a smaller spindle use a Gecko 340, larger spindle look at Rutex in
Australia. I haven't tried it (yet), I don't have an encoder on my
spindle.
Roger
> Depends on your controller. At present, the software-onlysolutions (Mach1, cncpro, etc) do not have this capability. Somebody
jump in if this is incorrect. Art will probably have it available in
Mach1 eventually. Cncpro seems to be in its final form.
Mach1 has spindle control via step and direction since last week. For
a smaller spindle use a Gecko 340, larger spindle look at Rutex in
Australia. I haven't tried it (yet), I don't have an encoder on my
spindle.
Roger
Discussion Thread
natchamp_87
2002-10-25 08:24:08 UTC
Is Single Phase Adequate?
Tim Goldstein
2002-10-25 09:14:13 UTC
Re: [CAD_CAM_EDM_DRO] Is Single Phase Adequate?
Doug Harrison
2002-10-25 09:18:16 UTC
Re: [CAD_CAM_EDM_DRO] Is Single Phase Adequate?
Jon Elson
2002-10-25 10:44:41 UTC
Re: [CAD_CAM_EDM_DRO] Is Single Phase Adequate?
Marv Frankel
2002-10-25 12:53:58 UTC
Re: [CAD_CAM_EDM_DRO] Is Single Phase Adequate?
Tim Goldstein
2002-10-25 13:16:25 UTC
Re: [CAD_CAM_EDM_DRO] Is Single Phase Adequate?
Country Bubba
2002-10-25 14:10:40 UTC
Re: [CAD_CAM_EDM_DRO] Is Single Phase Adequate?
Doug Harrison
2002-10-25 14:38:48 UTC
Re: [CAD_CAM_EDM_DRO] Is Single Phase Adequate?
vrsculptor
2002-10-25 14:56:26 UTC
Re: Is Single Phase Adequate? Spindle Speed Adj