RE: [CAD_CAM_EDM_DRO] using servo motors w/encoders for my DRO??
Posted by
Dan Mauch
on 2002-10-26 06:10:31 UTC
In addition to emc, deskncrt together with the Mauch/Kulaga DRO board
will take your encoder signals and process them as a dro with just using
the encoders mounted on servo motors but that portion of the display is
pretty small. If you want I can email you the Kulaga software that uses
a PC monitor as the display so you can see it.
Dan
mueller914 wrote:
will take your encoder signals and process them as a dro with just using
the encoders mounted on servo motors but that portion of the display is
pretty small. If you want I can email you the Kulaga software that uses
a PC monitor as the display so you can see it.
Dan
mueller914 wrote:
>With my servo controller turned off, is it feasible to use theSure.
>encoders off my servo motors for a DRO?
>
Discussion Thread
mueller914
2002-10-25 10:32:25 UTC
using servo motors w/encoders for my DRO??
Country Bubba
2002-10-25 14:24:46 UTC
Re: [CAD_CAM_EDM_DRO] using servo motors w/encoders for my DRO??
Jon Elson
2002-10-25 22:11:06 UTC
Re: [CAD_CAM_EDM_DRO] using servo motors w/encoders for my DRO??
Dan Mauch
2002-10-26 06:10:31 UTC
RE: [CAD_CAM_EDM_DRO] using servo motors w/encoders for my DRO??