nema 42 speed with API CMD-260 driver
Posted by
echnidna
on 2002-10-31 00:05:38 UTC
Hi Group
I have a nema 42 sanyo denki type number 103-8932-0240 stepper motor which I cannot find any data for on the sanyo website. It is a 3.6 volt 6.1 amp 8 wire motor that is probably very big overkill for my router but I already have it. Can anyone offer an educated guess of probable speed with a API CMD-260 controller running between 36 to 72 volts. I would prefer to use maximum microstep for smoothest possible cutting.
Bob Thomas
I have a nema 42 sanyo denki type number 103-8932-0240 stepper motor which I cannot find any data for on the sanyo website. It is a 3.6 volt 6.1 amp 8 wire motor that is probably very big overkill for my router but I already have it. Can anyone offer an educated guess of probable speed with a API CMD-260 controller running between 36 to 72 volts. I would prefer to use maximum microstep for smoothest possible cutting.
Bob Thomas