CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] Drill press & cross-slide vice

on 2002-10-31 00:07:27 UTC
I hear what you're saying about the slop in the drill press. Another idea I
thought of was to mount a hand router stationary above the cross slide.
Aren't routers supposed to be made for lateral pressures?

-----Original Message-----
From: Dan Mauch [mailto:dmauch@...]
Sent: Wednesday, October 30, 2002 6:21 PM
To: CAD_CAM_EDM_DRO@yahoogroups.com
Subject: RE: [CAD_CAM_EDM_DRO] Drill press & cross-slide vice


Been there and done that. I used the 5" version from harbor freight for
around 60.00 I had to take a lot of slop out of the drive mechanism and
made some stepper motor mounts. I install Torrington needle thurst
bearings on each axis. I used it to cnc drill some stepper motor mounts.
The problem is that you cannot use a drill press as a mill because of
the slop in the spindle assembly. The enco mill drill tables for $119 is
a better deal in the long run but figure out how you plan to do the
spindle first.
Dan


Confidentiality Warning
=======================
The contents of this e-mail and any accompanying documentation
are confidential and any use thereof, in what ever form, by anyone
other than the addressee is strictly prohibited.

Discussion Thread

vandersandtc 2002-10-30 07:15:20 UTC Drill press & cross-slide vice Dan Mauch 2002-10-30 08:19:08 UTC RE: [CAD_CAM_EDM_DRO] Drill press & cross-slide vice Van Der Sandt Coert 2002-10-31 00:07:27 UTC RE: [CAD_CAM_EDM_DRO] Drill press & cross-slide vice Dan Mauch 2002-10-31 07:11:39 UTC RE: [CAD_CAM_EDM_DRO] Drill press & cross-slide vice Dave Dillabough 2002-10-31 11:22:06 UTC RE: [CAD_CAM_EDM_DRO] Drill press & cross-slide vice turbulatordude 2002-10-31 18:05:28 UTC Re: Drill press & cross-slide vice JJ 2002-11-01 18:15:44 UTC RE: [CAD_CAM_EDM_DRO] Re: Drill press & cross-slide vice turbulatordude 2002-11-02 06:48:56 UTC Re: Drill press & cross-slide vice