[CAD_CAM_EDM_DRO] Stepper Motor for Mini-Mill
Posted by
Terry D Palmer
on 2002-11-06 12:51:33 UTC
I'm still trying to figure out what size stepper motors to use for a Homier Mini-Mill. I looked at message 45509 but I'm not sure what is meant by "push" The first calculation is Watts = IPM * Lbs / 531 where the Lbs represents the pounds to "push".
And is there anyone here that has a Mini-mill that could tell me what steppers you are using.
I'm guessing I need NEMA 34's, but am not sure of the torque required.
Appreciate any help.
Thanks
Terry
Northwest PA
And is there anyone here that has a Mini-mill that could tell me what steppers you are using.
I'm guessing I need NEMA 34's, but am not sure of the torque required.
Appreciate any help.
Thanks
Terry
Northwest PA
Discussion Thread
Terry D Palmer
2002-11-06 12:51:33 UTC
[CAD_CAM_EDM_DRO] Stepper Motor for Mini-Mill
aussiedude
2002-11-06 14:52:10 UTC
RE: [CAD_CAM_EDM_DRO] Hobbyist interface board for Printer port