Re: [CAD_CAM_EDM_DRO] DOS networking: How to use MSclient for DOS machine controllers
Posted by
Bob Simon
on 2002-11-12 12:26:29 UTC
At 15:33 11/11/2002 -0800, you wrote:
success with version 4.x, but you might consider the risk of problems to be
a bit too great. You could use a dual boot setup like Boot Magic or System
Commander to connect with the network to be on the safe side.
-Bob
>Bob,Ahha version 3.x won't even work with networking enabled. I've had some
>
>It is my understanding that AhHa, which is a DOS based CNC COntroller, is
>very picky about any interrupts or TSR's being loaded in memory.
success with version 4.x, but you might consider the risk of problems to be
a bit too great. You could use a dual boot setup like Boot Magic or System
Commander to connect with the network to be on the safe side.
-Bob
Discussion Thread
glee@i...
2002-11-11 14:22:43 UTC
Re: [CAD_CAM_EDM_DRO] DOS networking: How to use MSclient for DOS machine controllers
glee@i...
2002-11-11 15:33:04 UTC
Re: [CAD_CAM_EDM_DRO] DOS networking: How to use MSclient for DOS machine controllers
Bob Simon
2002-11-12 12:26:27 UTC
Re: [CAD_CAM_EDM_DRO] DOS networking: How to use MSclient for DOS machine controllers
Bob Simon
2002-11-12 12:26:29 UTC
Re: [CAD_CAM_EDM_DRO] DOS networking: How to use MSclient for DOS machine controllers
caudlet
2002-11-12 15:45:17 UTC
Re: DOS networking: How to use MSclient for DOS machine controllers
Bob Simon
2002-11-12 16:28:58 UTC
Re: [CAD_CAM_EDM_DRO] Re: DOS networking: How to use MSclient for DOS machine controllers