Re: Shinano Kenshi 24VDC Servo Motor with Encoder Res: 500...
Posted by
PTENGIN@a...
on 2000-02-08 01:10:31 UTC
In a message dated 02/07/2000 7:16:14 PM Hawaiian Standard Time,
multi-volti@... writes:
<< How much work can one really do with a 40W servomotor, compared to a NEMA
34
or 42 stepper?
Murray
If I did the math correct, I think the motor is good for approx 100 inch
oz of torque. The peak torque appears to be about 300 inch oz. Double check
it as I can hardly read the numbers too. If it can run up to 3000 RPM, seems
it would be a really neat Sherline axis drive. I'd gear it down a tad with a
XL cog belt drive. Should be fast. I suppose you need to come up with a low
cost servo controller though.....
Peter
THRD, Inc.
multi-volti@... writes:
<< How much work can one really do with a 40W servomotor, compared to a NEMA
34
or 42 stepper?
Murray
>>Murray,
If I did the math correct, I think the motor is good for approx 100 inch
oz of torque. The peak torque appears to be about 300 inch oz. Double check
it as I can hardly read the numbers too. If it can run up to 3000 RPM, seems
it would be a really neat Sherline axis drive. I'd gear it down a tad with a
XL cog belt drive. Should be fast. I suppose you need to come up with a low
cost servo controller though.....
Peter
THRD, Inc.