Re: [CAD_CAM_EDM_DRO] Remove Balancers?
Posted by
bjammin@i...
on 2002-12-10 05:14:23 UTC
At 09:42 AM 12/10/02 -0000, you wrote:
Regards, Hoyt McKagen
To prevent virus propogation, please don't put this addy in your book
Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
Best MC - http://www.freeyellow.com/members/batwings/best.html
Camping/Caving - http://www.freeyellow.com/members/batwings/caving.html
Two-Wheel-Tech List - http://batwings.freeyellow.com/2whfaq.html
Religious strife proves that there's no God
>We have Thermwood router with NEMA 42 step motors.No, you may lose steps w/o the extra inertial mass.
>These were full stepped with the old control, the motors have
>balancers on them (mid-band resonance?). Should I remove
>the balancers with a micro-step drive(Anaheim) for faster
>accleration?
Regards, Hoyt McKagen
To prevent virus propogation, please don't put this addy in your book
Belfab CNC - http://www.freeyellow.com/members/belfab/belfab.html
Best MC - http://www.freeyellow.com/members/batwings/best.html
Camping/Caving - http://www.freeyellow.com/members/batwings/caving.html
Two-Wheel-Tech List - http://batwings.freeyellow.com/2whfaq.html
Religious strife proves that there's no God
Discussion Thread
John Mesh <jmesh@h...
2002-12-10 01:42:40 UTC
Remove Balancers?
bjammin@i...
2002-12-10 05:14:23 UTC
Re: [CAD_CAM_EDM_DRO] Remove Balancers?
Jon Elson
2002-12-10 10:08:54 UTC
Re: [CAD_CAM_EDM_DRO] Remove Balancers?
John Mesh <jmesh@h...
2002-12-10 22:08:19 UTC
Re: Remove Balancers?
JanRwl@A...
2002-12-10 22:24:06 UTC
Re: [CAD_CAM_EDM_DRO] Re: Remove Balancers?