Thanks to the group
Posted by
volitan712003 <volitan@o...
on 2002-12-15 08:23:11 UTC
I now have a stepper sitting on top of my PC which I can make rotate
via a xylotex driver board and TurboCNC. This was my immediate short
term goal to get going, and after about a day and a half I'm there.
So I wanted to take a minute and thank everyone here who responds to
questions from us newbies. This hobby can sure make your head spin
when you are getting started, and the different keywords you need to
learn seem never-ending. Thanks to your patience and ability to "dumb
things down", I'm now well on my way.
So to you, I say "Cheers!"
Thanks
David
via a xylotex driver board and TurboCNC. This was my immediate short
term goal to get going, and after about a day and a half I'm there.
So I wanted to take a minute and thank everyone here who responds to
questions from us newbies. This hobby can sure make your head spin
when you are getting started, and the different keywords you need to
learn seem never-ending. Thanks to your patience and ability to "dumb
things down", I'm now well on my way.
So to you, I say "Cheers!"
Thanks
David