2 1/2d (vinyl cutter)
Posted by
Erie Patsellis
on 2002-12-17 08:35:38 UTC
anybody have any ideas for implementing 2 1/2d? I recently
inherited a vinyl cutter from another sign shop that was
at the wrong end of a fire extinguisher. (it wasn't on fire,
but it got covered in crud and in ins. co. wrote it off)
The controller is done for due to corrosion, but I have a
good, basic mechanism to use.(after I've disassembled and bead
blasted all the crud off)
my first thought is to use the z direction bit to trigger power
to the voice coil actuator, but in the past, I've had issues with
doing that.
any suggestions?
Erie Patsellis
Shelbyville Design & signworks
visit our website at: www.shelbyvilledesign.com
inherited a vinyl cutter from another sign shop that was
at the wrong end of a fire extinguisher. (it wasn't on fire,
but it got covered in crud and in ins. co. wrote it off)
The controller is done for due to corrosion, but I have a
good, basic mechanism to use.(after I've disassembled and bead
blasted all the crud off)
my first thought is to use the z direction bit to trigger power
to the voice coil actuator, but in the past, I've had issues with
doing that.
any suggestions?
Erie Patsellis
Shelbyville Design & signworks
visit our website at: www.shelbyvilledesign.com
Discussion Thread
Erie Patsellis
2002-12-17 08:35:38 UTC
2 1/2d (vinyl cutter)
Chris L
2002-12-17 21:36:15 UTC
Re: [CAD_CAM_EDM_DRO] 2 1/2d (vinyl cutter)
Erie Patsellis
2002-12-18 08:08:16 UTC
RE: [CAD_CAM_EDM_DRO] 2 1/2d (vinyl cutter)