Re: Linux and computer upgrade

----- Original Message -----
From: George Fouse <gfouse@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Friday, February 11, 2000 5:28 PM
Subject: Re: [CAD_CAM_EDM_DRO] Linux and computer upgrade


> From: George Fouse <gfouse@...>
>
> If you could please be a little more precise:
> 1. What precise hardware changes did you make, including memory, etc?

New AZZA MB K6 II 400 processor. Was an Explorer II with 200 MMX.

> 2. What is your hardware configuration?

New on board video is the only hardware change and I new I would have to re
configure Xwindows.

> 3. What kernel and rtl patch are you using?

Red Hat 5.2 2.0.36 and the patch that I got from this group.

> 4. What have you compiled into the kernel, (and what as modules)?

Not sure on this, I just followed Tim's directions to the letter.

> 5. What does your lilo.conf look like?

Where do I find that?

> 6. Document exactly where the hang occurs.

Screen reads:
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Floppy Drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.36.3 MAX_MD_DEV=3 MAX_REAL=8
Partition check:
hda: hda1 hda2 < hda5 hda6 >
VFS Mounted root (ext2 filesystem) readonly.
general protection: 0000
CPU: 0
EIP: 0010: [<00121ed6>]
EFLAGS: 00010206

After that it lists the registers and contents for the processor and quits.

Darrell

>
>
> Darrell Gehlsen wrote:
> >
> > From: "Darrell Gehlsen" <darrell@...>
> >
> > I just upgraded my computer with an AMD K6 II 400. I can boot Linux ok
but Rtlinux hangs just after
> > VFS mounted root (Ext2 file system) read only
> > Any ideas? or do I have to re install?
> > Darrell
> >
> -------------------------------
> George Fouse
>
> --------------------------- ONElist Sponsor ----------------------------
>
> GET A NEXTCARD VISA, in 30 seconds. Get rates as low as 0.0 percent
> Intro or 9.9 percent Fixed APR and no hidden fees. Apply NOW.
> <a href=" http://clickme.onelist.com/ad/NextcardCreative5SR ">Click
Here</a>
>
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>