RE: [CAD_CAM_EDM_DRO] Up andRunning...almost
Posted by
Tim Goldstein
on 2002-12-29 23:15:12 UTC
Can you tell us what it does when you use 1/2, 1/4, or 1/8 step?
Tim
[Denver CO]
Sherline Products at Deep Discount
Mach1 & DeskCNC with Credit Card ordering
Contact me for discounts on DeskCNC & Sherline bundles
www.KTMarketing.com/Sherline
Tim
[Denver CO]
Sherline Products at Deep Discount
Mach1 & DeskCNC with Credit Card ordering
Contact me for discounts on DeskCNC & Sherline bundles
www.KTMarketing.com/Sherline
> -----Original Message-----
> So far the only setup that works well
> is at full step on the Xylotec board and 4000 steps/inch (200
> step/rev X 20 TPI lead screw, direct drive). Suggestions on
> how to take advantage of 1/2, 1/4, or 1/8 step settings would
> be very welcome.
Discussion Thread
P. J. Hicks
2002-12-29 23:11:17 UTC
Up andRunning...almost
Tim Goldstein
2002-12-29 23:15:12 UTC
RE: [CAD_CAM_EDM_DRO] Up andRunning...almost