Re: Flex cables

I'm sorry, I thought this was about servo's
Yes, I have the 4 #24 in parallel & you are correct about that being
equivalent to 1 #18.
Correction, Belden 8723 is 2 pair, 22g.

> > From servo motors to amplifiers: Manhattan/CDT #M13193 (4pr/24g)
> > From encoder(motor end)to encoder(pc end): Belden 8723 (2pr/24g)
>
> Key word in first line is "servo", not "stepper"! A servo motor

would not

> draw the CURRENT the stepper would. FOUR pair for a servo? Did

you parallel

> these into ONE pair? Four #24 wires in parallel is about same as

one #18.

>
> Endcoder to PC? These would be "logic signals", and a single #48

would be

> "electrically" large enough (though clearly not "mechanically"

suitable).

>
>
>
>
> [Non-text portions of this message have been removed]