Re: Thread Calculator/CNCPro
Posted by
Jon Elson
on 2000-02-15 21:39:48 UTC
Paul Devey wrote:
On the lathe, you need the spindle encoder.
On the mill, for larger holes (about 3/8" and over) you can
use a thread mill, which somewhat resembles a tap but with
the rows of teeth all in a line, instead of a helix. Because these
units are expensive, and can be used for only one thread pitch,
I got a 1/4" single-row thread mill, which can do a wide range
of threads. It is really nice for cutting odd diameter threads, such
as camera lens threads, or anything much over 1/2", due to the
cost and torque required for the big taps.
Jon
> From: Paul Devey <Paul_Devey@...>That depends on whether you are talking about a mill or lathe.
>
> Speaking of CNCPro and things I'd like to see: the ability to cut
> threads
> using CNCPro. I gues that means having an encoder on the spindle to
> determine the phase relationship to the cutter?
On the lathe, you need the spindle encoder.
On the mill, for larger holes (about 3/8" and over) you can
use a thread mill, which somewhat resembles a tap but with
the rows of teeth all in a line, instead of a helix. Because these
units are expensive, and can be used for only one thread pitch,
I got a 1/4" single-row thread mill, which can do a wide range
of threads. It is really nice for cutting odd diameter threads, such
as camera lens threads, or anything much over 1/2", due to the
cost and torque required for the big taps.
Jon
Discussion Thread
Paul Devey
2000-02-15 21:02:44 UTC
RE: Thread Calculator/CNCPro
Jon Elson
2000-02-15 21:39:48 UTC
Re: Thread Calculator/CNCPro
Paul Devey
2000-02-15 22:20:58 UTC
RE: Thread Calculator/CNCPro