Re: [CAD_CAM_EDM_DRO] NEMA 34 motor mounting question

In a message dated 1/10/2003 8:40:53 PM Mountain Standard Time,
xyz@... writes:

> When I mount this to a plate I will have to remove that same amount of metal
> ( and a little extra) to ensure the motor is bolted flat to the mounting
> plate.
>

NO, NO, NO......... the round surface is for alignment/ registration, bore a
tight fitting hole in the mounting plate for it to fit in, quite snug fit is
desired..............
bill


[Non-text portions of this message have been removed]