Re: Poor Mans Cnc Router
Posted by
turbulatordude <davemucha@j...
on 2003-01-26 08:45:19 UTC
Hi,
What type of cam follower are you using ? I have seen plain bearings
on a ground shoulder bolt with an outter nylon wheel. That would
allow one to tap a hole, insert the unit and the outter ring would
then be the nylon.
Interesting design.
Dave
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "dakota8833
<dakota8833@b...>" <dakota8833@b...> wrote:
What type of cam follower are you using ? I have seen plain bearings
on a ground shoulder bolt with an outter nylon wheel. That would
allow one to tap a hole, insert the unit and the outter ring would
then be the nylon.
Interesting design.
Dave
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "dakota8833
<dakota8833@b...>" <dakota8833@b...> wrote:
> A While ago I mentioned building a cnc router table using camfollower
> rollers.completed
>
> Well I'm building it! Should take one more week to complete. I have
> made some changes since I uploaded the last cad files. Most of the
> improvements make assembly easier ( less parts ). After it's
> I'll upload the new cad files. You can see some picts of it at
> http://photos.groups.yahoo.com/group/CAD_CAM_EMC/lst Cnc Rout...
>
> Let me know what you think
>
> Frank
Discussion Thread
dakota8833 <dakota8833@b...
2003-01-25 17:30:27 UTC
Poor Mans Cnc Router
Bernard R <bwjarandall@c...
2003-01-26 06:27:51 UTC
Re: Poor Mans Cnc Router
dakota8833 <dakota8833@b...
2003-01-26 07:27:54 UTC
Re: Poor Mans Cnc Router
turbulatordude <davemucha@j...
2003-01-26 08:45:19 UTC
Re: Poor Mans Cnc Router
dakota8833 <dakota8833@b...
2003-01-26 13:56:26 UTC
Re: Poor Mans Cnc Router