For Trade: complete 2 axis servo system
Posted by
Todd Ferrante <tf0z@w...
on 2003-02-07 07:36:25 UTC
Like I posted earlier, I have some surplus stuff from work to trade.
It goes to whoever will pay for postage and give me the coolest stuff
in return. Machine tool type stuff preferred, but other creative
trades certainly considered. No guarantees on functionality, though
I didn't take anything that was labeled as "bad" in the pick-through
pile. I just couldn't bear to see stuff end up in the dumpster.
This was a benchtop test system for development of the servo controls
on one of our machines. It includes two servo motors, two servo
amplifiers, and a power supply. I think I have an extra Tech 80
servo control card around I can throw in as well. The motors have
disks on the shafts mounted so a variable load can be applied by
tightening screws that act like disk brakes. There are also a bunch
of limit switches. It is kind of heavy, so I would expect the
shipping to be about $20. But, hey, there is probably $2000 worth of
stuff here.
Two Pacific Scientific brushless servo motors w/ encoders
Part numbers R21GENA-HS-LB-NV-00 and R22GENA-HS-LB-NV-00
Data for these motors, starts on p23 of the PacSci High Performance
Servo Motor design guide found here:
http://www.pacsci.com/support/documents/pc800/svomtrs.pdf
Two Pacific Scientific servo amps, model number SC402-010
Power Supply is Power One model HCAA-60W-A
Pictures here:
http://www.wideopenwest.com/~toddf/trades/servosystem1.jpg
http://www.wideopenwest.com/~toddf/trades/servosystem2.jpg
Post or email me your trades, and I'll post when someone takes this.
Todd F.
It goes to whoever will pay for postage and give me the coolest stuff
in return. Machine tool type stuff preferred, but other creative
trades certainly considered. No guarantees on functionality, though
I didn't take anything that was labeled as "bad" in the pick-through
pile. I just couldn't bear to see stuff end up in the dumpster.
This was a benchtop test system for development of the servo controls
on one of our machines. It includes two servo motors, two servo
amplifiers, and a power supply. I think I have an extra Tech 80
servo control card around I can throw in as well. The motors have
disks on the shafts mounted so a variable load can be applied by
tightening screws that act like disk brakes. There are also a bunch
of limit switches. It is kind of heavy, so I would expect the
shipping to be about $20. But, hey, there is probably $2000 worth of
stuff here.
Two Pacific Scientific brushless servo motors w/ encoders
Part numbers R21GENA-HS-LB-NV-00 and R22GENA-HS-LB-NV-00
Data for these motors, starts on p23 of the PacSci High Performance
Servo Motor design guide found here:
http://www.pacsci.com/support/documents/pc800/svomtrs.pdf
Two Pacific Scientific servo amps, model number SC402-010
Power Supply is Power One model HCAA-60W-A
Pictures here:
http://www.wideopenwest.com/~toddf/trades/servosystem1.jpg
http://www.wideopenwest.com/~toddf/trades/servosystem2.jpg
Post or email me your trades, and I'll post when someone takes this.
Todd F.
Discussion Thread
Todd Ferrante <tf0z@w...
2003-02-07 07:36:25 UTC
For Trade: complete 2 axis servo system
wanliker@a...
2003-02-07 10:51:01 UTC
For Trade: complete 2 axis servo system