CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Trick for creating engraving paths for logos

Posted by James Stevens
on 2003-02-11 09:29:05 UTC
Even easier is RasterFratz. Just load up the graphic you want to trace and
select either DXF or Gcode (even PLC data) for the output. Out comes the
desired data - ready to machine.

James

Subject: RE: [CAD_CAM_EDM_DRO] Trick for creating engraving paths for logos


> adobe streamline makes it almost too easy...
>
>
> Erie Patsellis
> Shelbyville Design & signworks
> 217-774-4444
> erie@... <mailto:erie@...>
> Visit our website at: www.shelbyvilledesign.com

Discussion Thread

Chris and Dee <brunoblazer@y... 2003-02-11 08:27:27 UTC Trick for creating engraving paths for logos Daniel J. Statman 2003-02-11 08:36:53 UTC Re: [CAD_CAM_EDM_DRO] Trick for creating engraving paths for logos Erie Patsellis 2003-02-11 08:50:45 UTC RE: [CAD_CAM_EDM_DRO] Trick for creating engraving paths for logos James Stevens 2003-02-11 09:29:05 UTC Re: [CAD_CAM_EDM_DRO] Trick for creating engraving paths for logos Robert Adams 2003-02-11 10:32:44 UTC Re: [CAD_CAM_EDM_DRO] Trick for creating engraving paths for logos Jeff <rental@e... 2003-02-11 10:42:04 UTC Re: Trick for creating engraving paths for logos Randy Gordon-Gilmore 2003-02-11 10:49:18 UTC Coreldraw8, was Re: [CAD_CAM_EDM_DRO] Trick dodge1320 <motionin@a... 2003-02-11 19:08:58 UTC Re: Trick for creating engraving paths for logos James Cullins 2003-02-11 20:30:40 UTC Re: [CAD_CAM_EDM_DRO] Re: Trick for creating engraving paths for logos Daniel J. Statman 2003-02-11 20:42:24 UTC Re: [CAD_CAM_EDM_DRO] Re: Trick for creating engraving paths for logos