RE: Interface update

Four axis support is expected. Most commercial controls have this
capability built in but disabled. Since profit is not the prime motive,
there would be no reason to eliminate this $1.50 option.

> -----Original Message-----
> From: Craig C Chamberlin [SMTP:ccc@...]
> Sent: Wednesday, February 23, 2000 2:31 PM
> To: CAD_CAM_EDM_DRO@onelist.com
> Subject: Re: [CAD_CAM_EDM_DRO] Interface update
>
> From: Craig C Chamberlin <ccc@...>
>
> Doug,
>
> This is sounding very good to me...have been reading this thread and may
> have missed it, but what about fourth axis support...I
> would want it very much.
>
> Regards,
>
> Craig
>
>
>
> ------------------------------------------------------------------------
> Get what you deserve with NextCard Visa! ZERO! Rates as low as
> 0.0% Intro APR, online balance transfers, Rewards Points, no
> hidden fees, and much more! Get NextCard today and get the credit
> you deserve! Apply now! Get your NextCard Visa at:
> http://click.egroups.com/1/966/2/_/_/_/951334270/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager