Re: Interface update
Posted by
Craig C Chamberlin
on 2000-02-24 00:25:32 UTC
Doug,
If you deliver a board such as you are you are talking about, which works with CNCPro, I would be happy to pay to have your wife
assemble it...
So, an estimate of the cost of an assembled board...ballpark...would be good, it is it possible.
Regards,
Craig
If you deliver a board such as you are you are talking about, which works with CNCPro, I would be happy to pay to have your wife
assemble it...
So, an estimate of the cost of an assembled board...ballpark...would be good, it is it possible.
Regards,
Craig
Discussion Thread
Harrison, Doug
2000-02-23 09:31:05 UTC
RE: Interface update
Craig C Chamberlin
2000-02-23 11:31:19 UTC
Re: Interface update
Harrison, Doug
2000-02-23 11:58:24 UTC
RE: Interface update
Dean Sala
2000-02-23 14:47:57 UTC
Re: Interface update
Jon Elson
2000-02-23 16:19:14 UTC
Re: Interface update
Harrison, Doug
2000-02-23 16:12:37 UTC
RE: Interface update
Craig C Chamberlin
2000-02-23 17:11:02 UTC
Re: Interface update
Harrison, Doug
2000-02-23 18:50:59 UTC
RE: Interface update
Craig C Chamberlin
2000-02-24 00:25:32 UTC
Re: Interface update
Harrison, Doug
2000-02-24 05:01:49 UTC
RE: Interface update