CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] EMC pinout

on 2003-02-27 21:13:39 UTC
>
> Hi,
> I am a Mechanical Engineering student at UNC
> Charlotte and my senior design project is to retrofit
> a Bridgport mill with slo-syn controller to EMC
> control. Right now I am at a stage where I am trying
> to control a Step-syn stepper with a Qualidyne
> driver/power supply.
> The driver has a parport connection, but the pin
> configuration is different than the EMC standard
> paport pinout. Is there somewhere in the EMC
> configuration files where I can make a quick change to
> the pinout configuration?
>
> Thanks.

No, the only way to change the pinout is to change the source code and
recompile the whole works. What you can do, is go to radio shack and get a
RS-232 jumper box, which is 2 25 pin d-sub connectors connected together
with a small circuit board. It comes with some jumper wires, and you can,
for example, connect a jumper from pin 1 on one connector to pin 5 on
another, or whatever configuration you need. They cost about $3.00 or $4.00.

Bill

Discussion Thread

Glynn Newby 2003-02-27 20:44:36 UTC EMC pinout William Scalione 2003-02-27 21:13:39 UTC Re: [CAD_CAM_EDM_DRO] EMC pinout