Re: Motor/Axis Reversal?
Posted by
Andrew Mawson
on 2003-03-16 03:07:17 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Jon Elson <elson@p...> wrote:
done on the Gecko's or in Turbo CNC?
sense of the direction bit
From the initial menu page take:
Option 6 - Setup Machine Configuration
then Option 2 Axis Setup
then option 9 DIR pin state
Good luck
Andrew Mawson
Bromley,
Kent,
UK
>are reversed. How do I reverse the direction of each axis. Is that
>
> Fusion X Studio wrote:
>
> >I'm running some code on my machine and noticed that all my axis
done on the Gecko's or in Turbo CNC?
> >the
> >
> I don't know whether this is configurable in Turbo CNC. If it has a
> setup file, there may be a parameter in there for the polarity of
> direction bit.Yes TurboCNC has a machine configuration menu to set the logical
>
> Otherwise, just switch the wires of ONE phase of each stepper
> motor between the motor and the stepper driver.
>
> That will accomplish the reversal of the motors.
>
> Jon
sense of the direction bit
From the initial menu page take:
Option 6 - Setup Machine Configuration
then Option 2 Axis Setup
then option 9 DIR pin state
Good luck
Andrew Mawson
Bromley,
Kent,
UK
Discussion Thread
Fusion X Studio
2003-03-15 10:48:42 UTC
Motor/Axis Reversal?
Fusion X Studio
2003-03-15 11:50:49 UTC
Re: [CAD_CAM_EDM_DRO] Motor/Axis Reversal?
Jon Elson
2003-03-15 22:02:39 UTC
Re: [CAD_CAM_EDM_DRO] Motor/Axis Reversal?
Andrew Mawson
2003-03-16 03:07:17 UTC
Re: Motor/Axis Reversal?