Re: small servo motors keep stalling
Posted by
feck123
on 2003-03-20 21:39:31 UTC
yes after looking at the motors it says 5:9 ratio gear motor...is that good or
bad ? the 1/2-20 is bad too, buti gotta try to work with it for now...i know of
lots of people that have no problems with this setup using stepper
motors..is the servo setup a lot less tolerant of low pecision
machine/screw setups?..i do not know specs on the drivers and power
supply..i bought the whole setup from place called jra co.....website
jraco.com...the csp-1 system...it is a nice setup and should be ok --if i can
ever figure out how to mount my motors correctly ! :) --- thanks for the
help ! Mike
bad ? the 1/2-20 is bad too, buti gotta try to work with it for now...i know of
lots of people that have no problems with this setup using stepper
motors..is the servo setup a lot less tolerant of low pecision
machine/screw setups?..i do not know specs on the drivers and power
supply..i bought the whole setup from place called jra co.....website
jraco.com...the csp-1 system...it is a nice setup and should be ok --if i can
ever figure out how to mount my motors correctly ! :) --- thanks for the
help ! Mike
Discussion Thread
feck123
2003-03-20 17:27:44 UTC
small servo motors keep stalling
Jon Elson
2003-03-20 20:30:33 UTC
Re: [CAD_CAM_EDM_DRO] small servo motors keep stalling
feck123
2003-03-20 21:39:31 UTC
Re: small servo motors keep stalling
turbulatordude
2003-03-21 06:04:21 UTC
Re: small servo motors keep stalling
j.guenther
2003-03-21 07:58:22 UTC
RE: [CAD_CAM_EDM_DRO] Re: small servo motors keep stalling
Jon Elson
2003-03-21 10:28:27 UTC
Re: [CAD_CAM_EDM_DRO] Re: small servo motors keep stalling
Jon Elson
2003-03-21 10:31:47 UTC
Re: [CAD_CAM_EDM_DRO] Re: small servo motors keep stalling
feck123
2003-03-22 15:37:39 UTC
Re: small servo motors keep stalling
Jon Elson
2003-03-22 16:54:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: small servo motors keep stalling