posting
Posted by
PCSHAPER@a...
on 2000-02-26 23:05:57 UTC
To anyone who cares to respond,
I have a Shasuka (sp?) vertical mill with an old Summit-Bandit controller.
Needless to say, it is costing me a fortune to keep it working! This
particular
mill has servo motors and resolver position sensors. The Servo board is
working
OK, but something else is messed up. I am trying to locate someone who knows
an inexpensive PC based 3 axis servo control board that can work with
resolvers.
I also would like to know if anyone has a schematic of the resolver board (2
boards
bolted together) and any programming information on this board. I am an
electronics
engineer and am interested in making an interface between the PC bus and this
card
so that I can control the machine directly from a PC.
Anyone have any help ?
Barry W.
I have a Shasuka (sp?) vertical mill with an old Summit-Bandit controller.
Needless to say, it is costing me a fortune to keep it working! This
particular
mill has servo motors and resolver position sensors. The Servo board is
working
OK, but something else is messed up. I am trying to locate someone who knows
an inexpensive PC based 3 axis servo control board that can work with
resolvers.
I also would like to know if anyone has a schematic of the resolver board (2
boards
bolted together) and any programming information on this board. I am an
electronics
engineer and am interested in making an interface between the PC bus and this
card
so that I can control the machine directly from a PC.
Anyone have any help ?
Barry W.
Discussion Thread
PCSHAPER@a...
2000-02-26 23:05:57 UTC
posting
Steve Carlisle
2000-02-27 09:11:34 UTC
Re: posting
Fred Smith
2000-02-27 11:13:28 UTC
Re: posting
Jon Elson
2000-02-27 19:46:28 UTC
Re: posting
Matt Shaver
2000-02-27 21:07:06 UTC
Re: posting