Camtronics stepper motors ...
Posted by
Chris Baugher
on 2003-03-23 19:34:40 UTC
This is a question for Dan Mauch or anyone else that may know the answer.
Would the ~800oz-in. stepper motors listed on the Camtronics website be
sufficient to drive the X/Y axes of a bridgeport size mill with 5 TPI
ballscrews? If so what sort of rapid speeds could I expect (roughly
assuming Gecko drives at say 48V); OR are there specs on the motors
somewhere so that I can calculate it myself?
Thanks!
C|
Would the ~800oz-in. stepper motors listed on the Camtronics website be
sufficient to drive the X/Y axes of a bridgeport size mill with 5 TPI
ballscrews? If so what sort of rapid speeds could I expect (roughly
assuming Gecko drives at say 48V); OR are there specs on the motors
somewhere so that I can calculate it myself?
Thanks!
C|
Discussion Thread
tompiatt
2003-03-08 20:42:17 UTC
Finding servo motor voltage without specs.
Tim Goldstein
2003-03-08 21:13:50 UTC
RE: [CAD_CAM_EDM_DRO] Finding servo motor voltage without specs.
Jon Elson
2003-03-08 23:29:36 UTC
Re: [CAD_CAM_EDM_DRO] Finding servo motor voltage without specs.
jmkasunich
2003-03-09 12:19:07 UTC
Re: Finding servo motor voltage without specs.
Chris Baugher
2003-03-23 19:34:40 UTC
Camtronics stepper motors ...
vavaroutsos
2003-03-23 22:17:38 UTC
Re: Camtronics stepper motors ...