Step motor voltage question
Posted by
Ross
on 2003-03-28 09:12:19 UTC
Hi all...
I have a motor rated at 5V at 4A and my power suply is 12V at 12.5A. Ohms l=
aw says I
need a 1.75 ohm power resitor. Problem is that I can only find 1.5 and 2 o=
hms.
In your experience, can a good quality motor take a little more than it's
rated voltage? In other words, am I better off going with a little less
resistor and passing a little more current or should I go with a a little =
more
resistor and pass a little less current?
Thanks...Ross
Message 8423 of 8423 | Previous | Next [ Up Thread ]
Messag
I have a motor rated at 5V at 4A and my power suply is 12V at 12.5A. Ohms l=
aw says I
need a 1.75 ohm power resitor. Problem is that I can only find 1.5 and 2 o=
hms.
In your experience, can a good quality motor take a little more than it's
rated voltage? In other words, am I better off going with a little less
resistor and passing a little more current or should I go with a a little =
more
resistor and pass a little less current?
Thanks...Ross
Message 8423 of 8423 | Previous | Next [ Up Thread ]
Messag
Discussion Thread
Ross
2003-03-28 09:12:19 UTC
Step motor voltage question
turbulatordude
2003-03-28 11:18:33 UTC
Re: Step motor voltage question