Re: Stepper mount for Vertex H/V 6" rotory table ?
Posted by
Andrew Mawson
on 2003-03-31 23:41:13 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "markpowerplus" <mabw@b...>
wrote:
shop so tidy!)
It turns out that Tony Jeffree of Division Master fame does an
adaptor kit for the Vertex HV4 & HV6 at a very reasonable price so
I'm taking the lazy mans road of buying it.
Andrew Mawson
Bromley, Kent, UK
wrote:
> Andrew,Thanks for that Mark, much appreciated - nice photos (why is your
> Yes I have done just this on my 4 axis mill , I have some photos
> posted in the photo section , folder called Centec. I ended up
> using a 600 0z/in. stepper , bit of overkill perhaps but it was
> spare . Did have a 85 oz/in but too small! Have a look at the
> photos , if you need better shots let me know
> cheers
> Mark
shop so tidy!)
It turns out that Tony Jeffree of Division Master fame does an
adaptor kit for the Vertex HV4 & HV6 at a very reasonable price so
I'm taking the lazy mans road of buying it.
Andrew Mawson
Bromley, Kent, UK
Discussion Thread
Andrew Mawson
2003-03-30 14:15:55 UTC
Stepper mount for Vertex H/V 6" rotory table ?
Tony Jeffree
2003-03-30 14:22:05 UTC
Re: [CAD_CAM_EDM_DRO] Stepper mount for Vertex H/V 6" rotory table ?
markpowerplus
2003-03-31 16:09:57 UTC
Re: Stepper mount for Vertex H/V 6" rotory table ?
Andrew Mawson
2003-03-31 23:41:13 UTC
Re: Stepper mount for Vertex H/V 6" rotory table ?
fuddham
2003-05-02 19:54:52 UTC
Re: Stepper mount for Vertex H/V 6" rotory table ?
Tony Jeffree
2003-05-03 00:44:26 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper mount for Vertex H/V 6" rotory table ?
Andrew Mawson
2003-05-03 01:20:35 UTC
Re: Stepper mount for Vertex H/V 6" rotory table ?
Tony Jeffree
2003-05-05 01:17:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: Stepper mount for Vertex H/V 6" rotory table ?