Re: [CAD_CAM_EDM_DRO] Names is just about a week away.
Posted by
Matt Shaver
on 2003-04-17 20:34:07 UTC
On Thursday 17 April 2003 21:28, IMService wrote:
it and I'd like to see it in action. I'll have a couple EMC controlled
machines, and Steve Stallings will probably have something running TurboCNC.
What I'm hoping is that folks who're trying to decide on controller software
can check out the most common solutions side-by-side.
Matt
P.S. How 'bout CncPro? I remember that was the hot ticket not too long ago, is
anyone going to run that at the show?
P.P.S. There's usually a Flashcut guy there too, so you can see that as
well...
P.P.P.S. Did I forget any other packages that'll be there?
> We will be showing a new 1/2 cubic foot, CNC gantry router,Is anyone going to be there with a Mach1 controlled machine? I've never seen
> running DeskCNC, and maybe some other surprises too ;-)
it and I'd like to see it in action. I'll have a couple EMC controlled
machines, and Steve Stallings will probably have something running TurboCNC.
What I'm hoping is that folks who're trying to decide on controller software
can check out the most common solutions side-by-side.
Matt
P.S. How 'bout CncPro? I remember that was the hot ticket not too long ago, is
anyone going to run that at the show?
P.P.S. There's usually a Flashcut guy there too, so you can see that as
well...
P.P.P.S. Did I forget any other packages that'll be there?
Discussion Thread
IMService
2003-04-17 18:26:07 UTC
Names is just about a week away.
Matt Shaver
2003-04-17 20:34:07 UTC
Re: [CAD_CAM_EDM_DRO] Names is just about a week away.
dodge1320
2003-04-18 17:51:50 UTC
Re: Names is just about a week away.