Re: EMC minimill option/Parallel port issues
Posted by
Paul Devey
on 2000-03-03 12:01:24 UTC
Ian,
Do you have a schematic that you can share with us?
Paul
Do you have a schematic that you can share with us?
Paul
> I haven't heard of one of these, but I use a home-built board which isinto
> simply a handful of LEDs hooked up to a ULN2003 driver chip which plugs
> the parallel port and gives a clear indication of what is happening there.that
> For switch inputs, you can simply wire a 4k7 resistor from the pin to a 5v
> supply line and then pull it low with a switch to ground. I would think
> this is a better way than relying on a program running in the samecomputer
> as any faults in the computer are likely to get mimiced or ignored as when
> EMC is running.
>
>
> Ian
Discussion Thread
daveland@n...
2000-03-02 14:28:37 UTC
EMC minimill option/Parallel port issues
Darrell
2000-03-03 00:10:47 UTC
Re: EMC minimill option/Parallel port issues
Ian Wright
2000-03-03 04:35:14 UTC
Re: EMC minimill option/Parallel port issues
Ray Henry
2000-03-03 11:17:34 UTC
Re: EMC minimill option/Parallel port issues
Paul Devey
2000-03-03 12:01:24 UTC
Re: EMC minimill option/Parallel port issues
JanRwl@A...
2000-03-03 18:17:51 UTC
Re: EMC minimill option/Parallel port issues
Ray Henry
2000-03-04 07:55:34 UTC
Re: EMC minimill option/Parallel port issues