CAD CAM EDM DRO - Yahoo Group Archive

wire gauge and steppers

on 2003-04-20 09:50:32 UTC
Hi all,

I am trying to figure out the wire sizes needed inside my panel
between the transformer and rectifier-cap and Gecko's.

I want to use 4 Geckos, 3 set for 2.4 amps and one set for 1.5 amps.

Since the DC buss is 35 volts, I don't think 18 ga would be a problem
to the Geckos or to the Steppers.

I googled 'wire chart, 'wire gauge chart' and so forth, but have not
found any simple tables for rating 18 ga on a 24VAC line or on the DC
line. assuming the 24VDC runs about 4 inches, I hope 18 is fine.

Anyone have any links to either the calculatins or a chart ?

Dave

Discussion Thread

turbulatordude 2003-04-20 09:50:32 UTC wire gauge and steppers Dave Rigotti 2003-04-20 10:02:29 UTC Re: [CAD_CAM_EDM_DRO] wire gauge and steppers Harvey White 2003-04-21 08:18:09 UTC Re: [CAD_CAM_EDM_DRO] wire gauge and steppers JanRwl@A... 2003-04-21 14:05:51 UTC Re: [CAD_CAM_EDM_DRO] wire gauge and steppers turbulatordude 2003-04-21 15:10:04 UTC Re: wire gauge and steppers Harvey White 2003-04-21 21:15:32 UTC Re: [CAD_CAM_EDM_DRO] Re: wire gauge and steppers