Re: [CAD_CAM_EDM_DRO] wire gauge and steppers

Here ya go

http://www.alphawire.com/PAGES/383.CFM

Regards,
Dave Rigotti
Hobby CNC

----- Original Message -----
From: "turbulatordude" <davemucha@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Sunday, April 20, 2003 12:50 PM
Subject: [CAD_CAM_EDM_DRO] wire gauge and steppers


> Hi all,
>
> I am trying to figure out the wire sizes needed inside my panel
> between the transformer and rectifier-cap and Gecko's.
>
> I want to use 4 Geckos, 3 set for 2.4 amps and one set for 1.5 amps.
>
> Since the DC buss is 35 volts, I don't think 18 ga would be a problem
> to the Geckos or to the Steppers.
>
> I googled 'wire chart, 'wire gauge chart' and so forth, but have not
> found any simple tables for rating 18 ga on a 24VAC line or on the DC
> line. assuming the 24VDC runs about 4 inches, I hope 18 is fine.
>
> Anyone have any links to either the calculatins or a chart ?
>
> Dave
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>