Re: [CAD_CAM_EDM_DRO] Re: cad to gcode and arcs
Posted by
Chris Brick
on 2003-04-26 22:15:17 UTC
Fred and all,
First, thanks for all the responses.
port isn't working correctly. Hopefully I'll get that fixed tomorrow so I can do some
testing on that platform.
Chris
First, thanks for all the responses.
> Next question, what kind of controller software are you using that cannot cut aRight now I'm using Turbocnc. I have EMC installed on another machine but the parallel
> series of lines or a combination of arcs and lines with equal ease? Most of the
> controller designers have been beat up so bad over the last 2 or 3 years that most
> have stepped up to the plate and implemented some kind of Continuous contouring or
> similar
> trajectory planning that the drawing entity form does not affect the cutting
> capability.
port isn't working correctly. Hopefully I'll get that fixed tomorrow so I can do some
testing on that platform.
Chris
Discussion Thread
Chris Brick
2003-04-26 07:22:39 UTC
cad to gcode and arcs
caudlet
2003-04-26 07:52:25 UTC
Re: cad to gcode and arcs
notoneleft
2003-04-26 10:48:28 UTC
Re: cad to gcode and arcs
David Paulson
2003-04-26 16:42:13 UTC
RE: [CAD_CAM_EDM_DRO] cad to gcode and arcs
fortino
2003-04-26 17:14:48 UTC
Re: [CAD_CAM_EDM_DRO] cad to gcode and arcs
Fred Smith
2003-04-26 19:39:50 UTC
Re: cad to gcode and arcs
Chris Brick
2003-04-26 22:15:17 UTC
Re: [CAD_CAM_EDM_DRO] Re: cad to gcode and arcs
Jeff Goldberg
2003-04-27 13:55:55 UTC
RE: [CAD_CAM_EDM_DRO] cad to gcode and arcs