Re: [CAD_CAM_EDM_DRO] Austrailian bipolar driver Kits

I remember the instructions had a value in amps that was the limit before
you needed heat sinks. I think heat sinks were only required above 2 amps.
I am working with Bridgeport CNCs and they have about 80 volt power supplies
and the motors draw 8 amps.
Darrell

----- Original Message -----
From: Joe Vicars <jvicars@...>
To: <CAD_CAM_EDM_DRO@onelist.com>; <dgehlsen@...>
Sent: Monday, March 06, 2000 2:42 PM
Subject: Re: [CAD_CAM_EDM_DRO] Austrailian bipolar driver Kits


> From: Joe Vicars <jvicars@...>
>
> Any idea what it's good for? 1.5 A per phase?
>
>
> ------------------------------------------------------------------------
> GET A NEXTCARD VISA, in 30 seconds! Get rates as low as 0.0%
> Intro or 9.9% Fixed APR and no hidden fees. Apply NOW!
> http://click.egroups.com/1/937/1/_/423600/_/952378591/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>