Re: [CAD_CAM_EDM_DRO] 2 motors, same axis question from newbie
Posted by
Jon Elson
on 2003-05-01 22:51:15 UTC
robertokx wrote:
no two
steppers position exactly the same throughout the revolution. It would be
better to combine two servo motors with belts at the same end of the screw,
however, because the screw can vibrate like a torsion spring, and you don't
want to excite vibrational modes like this.
Jon
>If you have a long X axis lead screw & you dont have enough torque toYes, assuming servo motors. It would not be practical with steppers, as
>drive the screw with one motor, is it possible/practical to have
>another motor on the other end working in unison. The motor on the
>other end would ofcourse be set to rotate in the reverse direction.
>Can this be done?
>
>
no two
steppers position exactly the same throughout the revolution. It would be
better to combine two servo motors with belts at the same end of the screw,
however, because the screw can vibrate like a torsion spring, and you don't
want to excite vibrational modes like this.
Jon
Discussion Thread
robertokx
2003-05-01 15:17:16 UTC
2 motors, same axis question from newbie
caudlet
2003-05-01 21:25:53 UTC
Re: 2 motors, same axis question from newbie
Jon Elson
2003-05-01 22:51:15 UTC
Re: [CAD_CAM_EDM_DRO] 2 motors, same axis question from newbie