CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] rtlinux-2.0

Posted by Joel Jacobs
on 2000-03-07 09:48:04 UTC
----- Original Message -----
From: "Matt Shaver" <mshaver@...>
> > is suppose to allow multiple CPU's - I only have one CPU. Does
> > multiprocessing support have to be turned on for hard real-time support
to
> > work even it you only have one CPU?
>
> I don't think so, but I'm in the process of doing what you've done (get
> RTL2.0 going for the EMC) and I'll let you know how it goes for me. Did
you
> mean that SMP support was turned on in that particular example, or that it
> was turned on in the .config file for the pre-patched kernel?
>
> Matt

Hi Matt,
It was turned on in the example and to be honest, I can't remember how the
default config file was set up. I went through and played with the
settings. I got it compiled and working tho with SMP turned _off_ and one
of the example programs did seem to run ok that way. Then I was looking
over the install.phil file and saw that SMP was enabled.

Joel

Discussion Thread

Matt Shaver 2000-03-07 09:24:57 UTC Re: [CAD_CAM_EDM_DRO] rtlinux-2.0 Joel Jacobs 2000-03-07 09:48:04 UTC Re: [CAD_CAM_EDM_DRO] rtlinux-2.0 George Fouse 2000-03-07 10:19:54 UTC Re: [CAD_CAM_EDM_DRO] rtlinux-2.0 Joel Jacobs 2000-03-08 11:10:12 UTC Re: [CAD_CAM_EDM_DRO] rtlinux-2.0 jguenthe 2000-03-08 11:42:26 UTC RE: [CAD_CAM_EDM_DRO] rtlinux-2.0 Joel Jacobs 2000-03-08 11:52:10 UTC Re: [CAD_CAM_EDM_DRO] rtlinux-2.0 George Fouse 2000-03-08 12:21:22 UTC Re: [CAD_CAM_EDM_DRO] rtlinux-2.0